Measuring the water drain: Let’s begin by measuring the length and width of our water drain.

Marking the measurements: We now mark the taken measurements by adding 1 cm. extra for it will be filled with grout later on.

Cutting the tile: Let’s place the tile face-up in the tile cutter and align the traced cutting line with the guide on the cutter and let’s pull the handle towards ourselves.

Breaking the tile with pincers: Let’s break bits of the tile with pincers until we reach the section that has been traced and cut with the tile cutter.

Setting the tile: Let’s set the tile on where mortar exists. Then, we should settle the tile in its place by pressing down on it and knocking on it with a rubber mallet. A clump sound means that the tile is firmly in place.